pkdavis1739: I have the tools and skill to do this, but not the facilities. Thanks for
helping me understand what my mechanic is going to be doing next weekend.
1A Auto Parts:
성민 한: GOOD!
alty79: How do you know if the CV joint axles are bad?
1A Auto Parts: No you should not have to us a jack to keep the ball joint from spinning.
If it is spinning, you might have a bad ball joint.
rusty10162: hey a quick tip after you get the shaft lose from the hub turn the steering
wheel all the way so the tie rod is out this gives you more room to work
and makes it easier to pull the halfshaft out less fighting with it. this
has worked well for me on many occasions
1A Auto Parts: You may have to support the engine and drop the cradle down so you can get
the bar into the vehicle.
1A Auto Parts: Thanks for checking us out. Have a great day! 1aauto.com 888-844-3393
1A Auto Parts: Sometimes they will make a thumping noise, or you you try to move them from
side-to-side by hand, they may have some play in them. Hope this helps you
out. 1aauto.com 888-844-3393
casinokd: I'm trying to replace a stabilizer bar on a 07 v6 Saturn. Having a terrible
time feeding it through. Do you have to drop the frame which will drop the
motor to do this? Or am I just missing something. Anyone that's been
through this help.
Russ M: Thank you for providing this video. I used it to replace lace the driver
side axle on an '07 Vue. The only issue I had was that the axle nut was a
34mm not a 36mm.
fargobrad: Was the jack used on the ball joint to keep it from spinning while
tightening it up?
pugzlie18: The other day at school I did this to a Acura TL and I took a transmission
jack and used it to hold the strut and rotor assembly out of the way and I
had a straight shot at it for re installation.
How To Install Replace Front CV Axle Joint Chevy Equinox Saturn Vue 05-10 1AAuto.com4.6
out of 5